Español 
Français 
Netherlands 
English 
Deutsch 
United Kingdom 
MD+ Sealant
MD + is an elastic one-component sealant suitable for the gas and watertight sealing of cable entries.
With the application of the MD+ sealant, you will protect valuables from damage which is caused by gas and water leaks.
Gas and watertight according to NEN 2768
The MD+ sealant is easily applied from a skeleton gun. The high quality, one component, flexible sealant “MD+” is based on a silicon compound that cures with air (Humidity).
After application and full curing the thixotropic MD+ forms a plastic elastomer mass with special qualities effectively sealing and bonding, while providing a high level of durability.
Larger duct openings can be sealed in combination with our specially designed tri-flexible foam. This is available as a complete set FiloSeal +
- Flexible, one component, adhesive and sealing compound in a cartridge - (310ml)
- High levels of Gas and Water tightness
- Removable / Re-enterable
- Excellent adhesion
- Shows Fire resistance properties
- Resistant against Water, Alkaline, Chemical agents
- Resistant to Hydrogen Sulphide / Methane and many other Gases (NedLab)
- Non corrosive
- Solvent free
- Shock absorbing
- Non toxic, neutral and almost odourless
- Suitable for any shaped duct / bore hole / opening
- Quick and easy installation
- Seals common materials, PVC & PE sheathed cables, PILC
- Suitable for renovations, can be installed retrospectively
| Density | 1,2 gr/cm³ | |
| Flow | < 2mm | ISO 7390 |
| Colour | red-brown | |
| Skin over time | ± 15 minutes | 23°C/55%RH |
| Curing | 3 mm/24h | |
| Hardness | 30 shore A | DIN 53505 |
| Elongation | 100% | DIN 53504 |
| Tensile strength | 0,8 N/mm² | DIN 53504 |
| Operating temperature | +5°C to +40°C | |
| Temperature resistance | -40°C to +120°C |
| Más información | Toepassing:
|
|---|---|
| Home page product list | No |